3D Easter Tree Ornaments 3

As the post I had meant to publish last night only went up a few hours ago there will be two today.

The next punch art ornament is my little chick:

 

This ornament requires a little more work then the other two.

Supplies used as follows:

 

yellow and orange cardstock - Bazzill
2 black beads, approx. 3/8" size
punches: scallop oval (SU) - 8 shapes, Blossom Builder (SU) smallest leaf - 2 for the wings, medium crystal snowflake (PB) 2 in orange (feet) and 1 in yellow (feathers for top of head), small diamond (PB) for the beak.
small ribbon bow and thread for the hanger. I also added highlights to the eyes with a white painty pen.
Assembly - the body was done the same as the egg from the other day; score and fold all 8 scallop ovals down the center lengthwise and glue together joining the last with the first to create the a 3D oval. The beak was creased and folded across the middle and glued to the center front. The eyes were glued into the folds on either side of the beak and the wings to the back of those folds on either side. Trim the snowflakes for the feet and feathers as shown below:

The feet were folded across the middle and then glued to the bottom of the body. The feathers we folded in half and glue to the top of head along with the hanger thread. Then attach the bow to the front.
I used Mono Multi glue as it really holds well and dries fast.

Come back tomorrow for my 3D bunny instructions.